How To Repair The Umbrella Hole On A Table

Our dorsum patio is as steamy as information technology gets in the summer, and information technology'south sunny for the majority of the day (it's hot-auto-hot in the mornings especially!). At the same time, nosotros're surrounded byactually close neighbors and high fences, blocking whatever absurd breeze. The 'someday' plan is to add together an awning above the French door sliders leading into our kitchen, but in the meantime, we needed shade in the g, also. When we built our DIY patio table terminal twelvemonth, nosotros knew we'd eventually desire to bring in an umbrella, but at the time, we weren't certain of style – for instance, cantilever versus middle-of-the-table (that'due south definitely a technical term, by the way). In the end, nosotros landed on this pretty 9′ rectangular umbrella, which meant we too needed to add a pigsty to our table.

Not surprisingly, you lot tin can turn any regular ol' tabular array into ane that can accommodate an umbrella with only a few uncomplicated tools – an umbrella for every tabular array, we say! Then, hither'due south how we DIYed an umbrella hole (considering in that location's really no other fashion to say it!).

Supplies + Tools Used

Umbrella!
Drill
Extra long drill scrap
1 1/ii″ Spade bit
Dremel w/ sanding band (or sandpaper)
Woods filler (optional)
Affect-up paint + brush
Hose clamp
Measuring record
Pencil

What Nosotros Did:

After measuring and marking the center point of our table, we used an actress long drill bit to get through the two layers of 2x4s that made up our tabletop – the frame underneath is i and the finished 2x4s lining the top are another. This was used as a preventative guide but; if your tabular array is fabricated from one layer, you could likely skip this step.

Our umbrella pole has a 1 1/two″ diameter, and then we picked upwards – yous guessed information technology – a i 1/2″ spade chip from the hardware store. Advisedly using the pilot hole equally a guide, Scott used the spade bit to go through the tabletop. The bit initially jumped around at first (largely due to going through the drainage line), and although it was't the cleanest cutting, it's an piece of cake enough fix with a bit of wood filler:

In our case, nosotros likewise had a bottom back up to get through. Y'all know how I just said you could skip the pilot hole if your tabletop is made from a unmarried layer? This bottom support is a solid iv×4, so we nixed the pilot hole birthday, and the spade bit went all the style through like butter!

Nosotros used our Dremel with a sanding band to quickly clean up the crude edges, but a sheet of sandpaper – and a bit of patience – would do the trick, besides! Afterwards, I touched up those splintered areas with wood filler, sandedthat down, and I finished upward with a paintbrush to smoosh impact-up paint into the umbrella holes.Side annotation: our table color is Thorntree by Sherwin Williams.

For the last step, nosotros slid the umbrella through both holes, and Scott secured a hose clamp around the pole and underneath the bottom support. If your umbrella comes with a heavy, solid stand, this pace could be skipped, just in our case, nosotros wanted to make sure in that location was absolutelyno style our umbrella could sail away in a strong gust of current of air!

Once it was in place, nosotros excitedly cranked up the umbrella! The height, the texture and that clean white shade instantly brought in the coziest vibe.